Ez-access PATHWA MODULAR ACCESS SYSTEM Instrukcja Użytkownika Pobierz pdf (Strona 31)

- 31 -

FIG. 6.4

6.1.3.

Cut the 1-1/2″ diameter round tube to the length measured (FIG. 6.2).

6.1.4.

Using a metal file, smooth any sharp edges from the cutting.

6.1.5.

Disassemble adjustable elbow by removing the screw and nut (FIG. 6.3).

6.1.6.

Install an elbow half into each end of the cut tube (FIG. 6.3).

6.1.7.

Tighten internal set screws a T-handle Allen wrench or similar tool (FIG. 6.3).

6.1.8.

Reassemble elbow by replacing center insert and securing with the screw and

nut, then tighten all fasteners securely (FIG. 6.4).

6.1.9.

Test to ensure elbows are properly secured and attached. If needed, tighten

internal set screws to secure more rigidly.

6.1.10.

For platforms over 5’ wide, use two MHRPRC (CONNECTOR – PLATFORM

HR TO RAMP HR) to connect ramp handrails instead of the MHRRRC (FIG.

6.5).

6.1.11.

Handrails for the inside of turn back platforms (two platforms connected) are

connected using the MHRRRC (CONNECTOR – RAMP HR TO RAMP HR)

(FIG. 6.6). A minimum of distance of 8” is required between the ramp side

rails in order to install the connectors.

FIG. 6.5

FIG. 6.6

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 48 49

Brak uwag

Ez-access PATHWA MODULAR ACCESS SYSTEM Instrukcja Użytkownika Strona 31